CY74FCT574TSOCTG4 Overview
20-SOIC (0.295, 7.50mm Width)is the way it is packaged. There is an embedded version in the package Tape & Reel (TR). Currently, the output is configured to use Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. Surface Mountis positioned in the way of this electronic part. The supply voltage is set to 4.75V~5.25V. It is operating at -40°C~85°C TA. This D latch has the type D-Type. In FPGA terms, D flip flop is a type of 74FCTseries FPGA. In total, it contains 1 elements. It consumes 200μA of quiescent Currently, there are 20 terminations. The 74FCT574 family contains this object. It is powered from a supply voltage of 5V. Input capacitance of this device is 5pF farads. It is a member of the FCTfamily of D flip flop. There is an electronic part mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. It is part of the FF/Latchesbase part number family. 8bits are used in its design. Vsup reaches 5.25V, the maximal supply voltage. Normal operation requires a supply voltage (Vsup) above 4.75V. On the basis of its reliable performance, this D flip flop is well suited for use with TAPE AND REEL. There are 5V power supplies attached to it. The flip flop has 2ports embedded within it. To operate, the chip has a total of 8 output lines.
CY74FCT574TSOCTG4 Features
Tape & Reel (TR) package
74FCT series
20 pins
8 Bits
5V power supplies
CY74FCT574TSOCTG4 Applications
There are a lot of Texas Instruments CY74FCT574TSOCTG4 Flip Flops applications.
- ATE
- Modulo – n – counter
- Communications
- Bounce elimination switch
- Dynamic threshold performance
- Data storage
- Counters
- Count Modes
- Shift Registers
- Frequency Dividers
