MAX4595DBVRG4 Overview

Shipping overseas is convenient with the electronic component packed in SC-74A, SOT-753. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. A total of 5 terminations have been recorded. By its 1 channels, the electronic component provides high-quality output. A 3V voltage supply should turn on and run the electronic component. There is an electrical component included in the 5 series. These analog multiplexers are built based on SPST - NC switching circuits. Search with MAX4595 if you are looking for analog multiplexer variants. In this multiplexer, the internal resistance is 10Ohm. You can find the functions of the 5 pins in the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. normally, users should not supply switches with voltages higher than 5.5V. Analogue multiplexers of the Single supply type that are cost-effective. It is recommended to use 2V as the lowest voltage for the electrical part. It would be sufficient to run this analogue multiplexer with 1μA current. Draining from a single voltage supply, this analog switch requires a voltage of 2.4V~5.5V. Putting voltage greater than 1μA on the multiplexer may cause damage. There are 300MHz bandwidths for data transfer.

MAX4595DBVRG4 Features

1 Channels
Switch Circuit: SPST - NC
1μA Supply Current
Bandwidth: 300MHz

MAX4595DBVRG4 Applications

There are a lot of Texas Instruments MAX4595DBVRG4 Analog Switches & Multiplexers ICs applications.

• Remote Powered Equipment
• Routers
• Cable Telephony – NIU, Set-Top Box, Home Side Box
• Microprocessor controlled systems
• 65 V DACs
• Power routing
• Battery Powered Systems
• Residential Gateways, Home Gateway/Router
• Video signal routing
• ATM