SN74ABT16821DGGR Overview

As a result, it is packaged as 56-TFSOP (0.240, 6.10mm Width). The package Cut Tape (CT)contains it. In the configuration, Tri-State, Non-Invertedis used as the output. This trigger is configured to use Positive Edge. Surface Mountis occupied by this electronic component. A 4.5V~5.5Vsupply voltage is required for it to operate. The operating temperature is -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. JK flip flop is a part of the 74ABTseries of FPGAs. This D flip flop should not have a frequency greater than 150MHz. D latch consists of 2 elements. This process consumes 500μA quiescents. 56terminations have occurred. The 74ABT16821 family contains this object. A voltage of 5V is used as the power supply for this D latch. This T flip flop has a capacitance of 3.5pF farads at the input. This D flip flop belongs to the family of ABT. There is an electronic part mounted in the way of Surface Mount. Basically, it is designed with a set of 56 pins. Its clock edge trigger type is Positive Edge. It is included in FF/Latches. There are 20bits in this flip flop. This D flip flop is well suited for TR based on its reliable performance. The power supply is 5V. The flip flop contains 2ports. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. With an output current of 64mA, it is possible to design the device in any way you want. In order to operate, the chip has 10 output lines.

SN74ABT16821DGGR Features

Cut Tape (CT) package
74ABT series
56 pins
20 Bits
5V power supplies

SN74ABT16821DGGR Applications

There are a lot of Texas Instruments SN74ABT16821DGGR Flip Flops applications.

• Data Synchronizers
• Matched Rise and Fall
• Convert a momentary switch to a toggle switch
• Reduced system switching noise
• Asynchronous counter
• EMI reduction circuitry
• Cold spare funcion
• Storage registers
• Buffer registers
• Modulo – n – counter