SN74ABT374ADWR Overview

In the form of 20-SOIC (0.295, 7.50mm Width), it has been packaged. The Cut Tape (CT)package contains it. T flip flop uses Tri-State, Non-Invertedas its output configuration. There is a trigger configured with Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. It is operating at -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. JK flip flop is a part of the 74ABTseries of FPGAs. Its output frequency should not exceed 200MHz Hz. There are 1 elements in it. It consumes 250μA of quiescent A total of 20terminations have been recorded. The 74ABT374 family contains it. A voltage of 5V is used to power it. This T flip flop has a capacitance of 3.5pF farads at the input. This D flip flop belongs to the family of ABT. This electronic part is mounted in the way of Surface Mount. A total of 20pins are provided on this board. This device's clock edge trigger type is Positive Edge. The part you are looking for is included in FF/Latches. 8bits are used in its design. Its superior flexibility is attributed to its use of 8 circuits. In view of its reliability, this D flip flop is a good fit for TR. The power supply is 5V. The flip flop contains 2ports. High efficiency requires the supply voltage to be maintained at 5V. With a current output of 64mA , it offers maximum design flexibility. It has 3 output lines to operate.

SN74ABT374ADWR Features

Cut Tape (CT) package
74ABT series
20 pins
8 Bits
5V power supplies

SN74ABT374ADWR Applications

There are a lot of Texas Instruments SN74ABT374ADWR Flip Flops applications.

• Storage registers
• Safety Clamp
• Reduced system switching noise
• High Performance Logic for test systems
• Registers
• Single Down Count-Control Line
• Balanced Propagation Delays
• EMI reduction circuitry
• Digital electronics systems
• Matched Rise and Fall