SN74ABT377ADWG4 Overview
The flip flop is packaged in a case of SOIC. It is configured with TTLas an output. D latch consists of 1 elements. Terminations are 20. The power source is powered by 5V. Electronic devices of this type belong to the ABTfamily. Electronic part Surface Mountis mounted in the way. With its 20pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. Due to its reliability, this T flip flop is well suited for TUBE. The D latch runs on a voltage of 5V volts. In order to ensure high efficiency, the supply voltage should remain at 5V. Additionally, you may refer to the additional WITH HOLD MODE of the electronic flip flop. It is set to -32mAfor the high level output current. It is set to 64mAfor the low level output current. If the operating temperature is lower than 85°C, it is recommended. It should be higher than -40°Cwhen the system is operating. Normally, it operates with a voltage of 4.5VV as its minimum supply voltage. It supports a maximum supply voltage of 5.5V volts. This frequency can be achieved 150MHz. In this case, it uses a D FLIP-FLOP logic IC. It is equipped with 1 functions . The D latch is equipped with 20 pins. As a result of its output current of 64mA, it is very flexible in terms of design.
SN74ABT377ADWG4 Features
20 pins
5V power supplies
1 Functions
20 pin count
SN74ABT377ADWG4 Applications
There are a lot of Texas Instruments
SN74ABT377ADWG4 Flip Flops applications.
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
- Asynchronous counter
