SN74AC374DWRE4 Overview

The package is in the form of SOIC. As part of the package Tape & Reel (TR), it is embedded. 20terminations have occurred. It is powered by a voltage of 3.3V . A device of this type belongs to the family of AC. It is mounted in the way of Surface Mount. There are 20pins on it. The clock edge trigger type for this device is Positive Edge. The RS flip flops belongs to FF/Latches base part number. An electronic part with 8bits has been designed. In order to achieve its superior flexibility, 8 circuits are used. A reliable performance of this D flip flop makes it well suited for use in TR. The flip flop contains 2ports. There are no output lines on the JK flip flop. 3input lines are available for you to choose from. A high level output current of -24mAis set. In the low level output current setting, the current is set to 24mA. Ideally, the operating temperature should be below 85°C. If the operating temperature is higher than -40°C, the system should operate properly. In order for it to operate, a supply voltage of 2Vis required. A maximum voltage of 6V can be provided by it. This frequency can be achieved at 155MHz. There is a logic IC BUS DRIVER used in the D flip flop. It has 1 functions. 20pins are available on this JK flip flop. With an output current of 24mA, this flip flop offers maximum design flexibility.

SN74AC374DWRE4 Features

Tape & Reel (TR) package
20 pins
8 Bits
1 Functions
20 pin count

SN74AC374DWRE4 Applications

There are a lot of Texas Instruments
SN74AC374DWRE4 Flip Flops applications.

• Frequency Dividers
• Shift Registers
• Storage Registers
• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division