SN74ACT574DBR Overview

The flip flop is packaged in a case of 20-SSOP (0.209, 5.30mm Width). A package named Cut Tape (CT)includes it. T flip flop is configured with an output of Tri-State, Non-Inverted. The trigger it is configured with uses Positive Edge. The electronic part is mounted in the way of Surface Mount. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. Temperature is set to -40°C~85°C TA. It belongs to the type D-Typeof flip flops. It belongs to the 74ACTseries of FPGAs. A frequency of 110MHzshould be the maximum output frequency. In total, there are 1 elements. It consumes 4μA of quiescent current without being affected by external factors. A total of 20 terminations have been made. It is a member of the 74ACT574 family. A voltage of 5V is used as the power supply for this D latch. A 4.5pFfarad input capacitance is provided by this T flip flop. In this case, the D flip flop belongs to the ACTfamily. The electronic part is mounted in the way of Surface Mount. It is designed with 20 pins. A Positive Edgeclock edge trigger is used in this device. This device is part of the FF/Latchesbase part number family. There are 8bits in its design. Due to its superior flexibility, it uses 8 circuits. As a result of its reliability, this D flip flop is ideally suited for TR. The D latch operates on 5V volts. There are 2 ports embedded in the flip flops. In order to achieve high efficiency, the supply voltage should be maintained at 5V. This T flip flop features a maximum design flexibility due to its output current of 24mA. Currently, there are 3 lines of input.

SN74ACT574DBR Features

Cut Tape (CT) package
74ACT series
20 pins
8 Bits
5V power supplies

SN74ACT574DBR Applications

There are a lot of Texas Instruments SN74ACT574DBR Flip Flops applications.

• Asynchronous counter
• Cold spare funcion
• Common Clocks
• Data transfer
• Synchronous counter
• Bus hold
• Circuit Design
• Divide a clock signal by 2 or 4
• Single Down Count-Control Line
• ESD performance