SN74AHC574DWRE4 Overview
The flip flop is packaged in SOIC. Package Tape & Reel (TR)embeds it. Currently, there are 20 terminations. The D flip flop is powered by a voltage of 3.3V . Devices in the AHC/VHC/H/U/Vfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. An electronic part designed with 8bits is used in this application. Its superior flexibility is attributed to its use of 8 circuits. As a result of its reliable performance, this T flip flop is suitable for TR. A D flip flop with 2embedded ports is available. It has 1 output lines to operate. As of now, there are 3input lines. -8mA is set as the high level output current. In the low level output current setting, 8mAis used. It is recommended that the operating temperature be below 125°C. Ideally, the operating temperature should be higher than -40°C. A minimum supply voltage of 2V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 5.5V. It is possible to achieve 115MHz frequencies. It uses a logic IC with a BUS DRIVER value. A total of 1 functions are available on the T flip flop. There are 20 pins on the D latch. This flip flop features a maximum design flexibility due to its output current of 8mA.
SN74AHC574DWRE4 Features
Tape & Reel (TR) package
20 pins
8 Bits
1 Functions
20 pin count
SN74AHC574DWRE4 Applications
There are a lot of Texas Instruments
SN74AHC574DWRE4 Flip Flops applications.
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
