SN74AHCT74DR Overview

It is packaged in the way of 14-SOIC (0.154, 3.90mm Width). A package named Cut Tape (CT)includes it. There is a Differentialoutput configured with it. It is configured with a trigger that uses Positive Edge. Surface Mountis occupied by this electronic component. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at -40°C~125°C TA. This D latch has the type D-Type. It belongs to the 74AHCTseries of FPGAs. It should not exceed 140MHzin terms of its output frequency. In 14terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. It is a member of the 74AHCT74 family. A voltage of 5V provides power to the D latch. The input capacitance of this T flip flop is 2pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. In this case, the D flip flop belongs to the AHCT/VHCT/VTfamily. There is an electronic part that is mounted in the way of Surface Mount. The 14pins are designed into the board. This device has the clock edge trigger type of Positive Edge. The part you are looking for is included in FF/Latches. Due to its superior flexibility, it uses 2 circuits. As a result of its reliability, this D flip flop is ideally suited for TR. A total of 5V power supplies are needed to run it. In order to achieve high efficiency, the supply voltage should be maintained at 5V. Currently, there are 4 input lines present. It consumes 2μA current.

SN74AHCT74DR Features

Cut Tape (CT) package
74AHCT series
14 pins
5V power supplies

SN74AHCT74DR Applications

There are a lot of Texas Instruments SN74AHCT74DR Flip Flops applications.

• Single Up Count-Control Line
• High Performance Logic for test systems
• Automotive
• Count Modes
• Consumer
• Latch
• Reduced system switching noise
• Memory
• Set-reset capability
• Circuit Design