SN74ALS112ANSR Overview

The flip flop is packaged in a case of 16-SOIC (0.209, 5.30mm Width). D flip flop is included in the Tape & Reel (TR)package. Currently, the output is configured to use Differential. JK flip flop uses Negative Edgeas the trigger. This electronic part is mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. Temperature is set to 0°C~70°C TA. Logic flip flops of this type are classified as JK Type. This type of FPGA is a part of the 74ALS series. There should be no greater frequency than 30MHzon its output. There is a consumption of 4.5mAof quiescent energy. Currently, there are 16 terminations. The 74ALS112 family contains it. Power is supplied from a voltage of 5V volts. In this case, the D flip flop belongs to the ALSfamily. It is mounted by the way of Surface Mount. 16pins are included in its design. This device has the clock edge trigger type of Negative Edge. This device is part of the FF/Latchesbase part number family. Its superior flexibility is attributed to its use of 2 circuits. Considering its reliability, this T flip flop is well suited for TR. The system runs on a power supply of 5V watts. In order to ensure high efficiency, the supply voltage should remain at 5V. In addition to its maximum design flexibility, the output current of the T flip flop is 8mA. Currently, there are 5 input lines present.

SN74ALS112ANSR Features

Tape & Reel (TR) package
74ALS series
16 pins
5V power supplies

SN74ALS112ANSR Applications

There are a lot of Texas Instruments SN74ALS112ANSR Flip Flops applications.

• Shift registers
• Consumer
• Shift Registers
• Single Down Count-Control Line
• EMI reduction circuitry
• Functionally equivalent to the MC10/100EL29
• Storage Registers
• Count Modes
• Individual Asynchronous Resets
• Event Detectors