SN74ALS374ADWG4 Overview
In the form of SOIC, it has been packaged. T flip flop uses TTLas its output configuration. The number of terminations is 20. An input voltage of 5Vpowers the D latch. In this case, the D flip flop belongs to the ALSfamily. There is an electronic component mounted in the way of Surface Mount. 20pins are included in its design. This device's clock edge trigger type is Positive Edge. It is designed with a number of bits of 8. Using 8 circuits, it is highly flexible. In view of its reliability, this D flip flop is a good fit for TUBE. In order for the device to operate, it requires 5V power supplies. The flip flop has 2embedded ports. In order to achieve high efficiency, the supply voltage should be maintained at 5V. The JK flip flop is with 1 output lines to operate. The number of input lines is 3. In this case, the high level output current is set to -2.6mA. 24mAis set as the low level output current. There should be a temperature below 70°Cduring operation. In order for the system to operate properly, the temperature should be higher than 0°C. The RS flip flop is designed to operate with a minimal supply voltage of 4.5VV. There is a maximum voltage support of 5.5V. A frequency of 35MHzcan be achieved. BUS DRIVERis the logic IC it uses. There are 1 functions available on this T flip flop. A total of 20 pins are present on this device. Its output current of 24mA allows for maximum design flexibility.
SN74ALS374ADWG4 Features
20 pins
8 Bits
5V power supplies
1 Functions
20 pin count
SN74ALS374ADWG4 Applications
There are a lot of Texas Instruments
SN74ALS374ADWG4 Flip Flops applications.
- Counters
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
