SN74ALS577ADWR Overview

24-SOIC (0.295, 7.50mm Width)is the packaging method. It is included in the package Tape & Reel (TR). There is a Tri-State, Invertedoutput configured with it. This trigger is configured to use Positive Edge. Surface Mountmounts this electrical part. A 4.5V~5.5Vsupply voltage is required for it to operate. It is operating at a temperature of 0°C~70°C TA. The type of this D latch is D-Type. In terms of FPGAs, it belongs to the 74ALS series. This D flip flop should not have a frequency greater than 30MHz. The list contains 1 elements. It consumes 18mA of quiescent In 24terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. D latch belongs to the 74ALS577 family. A voltage of 5V is used as the power supply for this D latch. In terms of electronic devices, this device belongs to the ALSfamily of devices. There is an electronic component mounted in the way of Surface Mount. This board is designed with 24pins on it. The clock edge trigger type for this device is Positive Edge. The part is included in FF/Latches. It is designed with 8bits. The superior flexibility of this product is achieved by using 8 circuits. Due to its reliability, this T flip flop is well suited for TR. The power supply is 5V. A total of 2ports are embedded in the D flip flop. If high efficiency is desired, the supply voltage should be kept at 5V. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. Currently, there are 4 input lines present. Furthermore, it has WITH SYNCHRONOUS CLEARas a characteristic.

SN74ALS577ADWR Features

Tape & Reel (TR) package
74ALS series
24 pins
8 Bits
5V power supplies

SN74ALS577ADWR Applications

There are a lot of Texas Instruments SN74ALS577ADWR Flip Flops applications.

• Event Detectors
• Latch
• Circuit Design
• Data storage
• CMOS Process
• Dynamic threshold performance
• Safety Clamp
• Single Up Count-Control Line
• Power down protection
• Control circuits