SN74AS174D Overview

16-SOIC (0.154, 3.90mm Width)is the way it is packaged. D flip flop is included in the Tubepackage. Currently, the output is configured to use Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. A 4.5V~5.5Vsupply voltage is required for it to operate. In this case, the operating temperature is 0°C~70°C TA. D-Typeis the type of this D latch. In terms of FPGAs, it belongs to the 74AS series. Its output frequency should not exceed 100MHz. A total of 1 elements are present. It consumes 45mA of quiescent In 16terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. It is a member of the 74AS174 family. A voltage of 5V provides power to the D latch. This D flip flop belongs to the family of AS. There is an electronic part mounted in the way of Surface Mount. A total of 16pins are provided on this board. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. 7 circuits are used to achieve its superior flexibility. In order to ensure high efficiency, the supply voltage should remain at 5V. It offers maximum design flexibility with its output current of 20mA. It has 2 output lines to operate. A total of 3input lines have been provided.

SN74AS174D Features

Tube package
74AS series
16 pins

SN74AS174D Applications

There are a lot of Texas Instruments SN74AS174D Flip Flops applications.

• Latch
• Synchronous counter
• Communications
• Buffer registers
• Dynamic threshold performance
• Data transfer
• Single Down Count-Control Line
• Clock pulse
• Patented noise
• Digital electronics systems