SN74AS825ADWRE4 Overview

The flip flop is packaged in a case of 24-SOIC (0.295, 7.50mm Width). You can find it in the Tape & Reel (TR)package. In the configuration, Tri-State, Non-Invertedis used as the output. It is configured with the trigger Positive Edge. It is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. In this case, the operating temperature is 0°C~70°C TA. It belongs to the type D-Typeof flip flops. JK flip flop belongs to the 74ASseries of FPGAs. D latch consists of 1 elements. Despite external influences, it consumes 73mAof quiescent current. In 24terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. If you search by 74AS825, you will find similar parts. The power source is powered by 5V. This D flip flop belongs to the family of AS. It is mounted by the way of Surface Mount. Basically, it is designed with a set of 24 pins. Its clock edge trigger type is Positive Edge. This part is included in FF/Latches. On the basis of its reliable performance, this D flip flop is well suited for use with TAPE AND REEL. The system runs on a power supply of 5V watts. A total of 2ports are embedded in the D flip flop. It is reported that there are 5 input lines. Additionally, there are WITH TRIPLE OUTPUT ENABLE; WITH CLEAR AND CLOCK ENABLE on the electronic flip flop that can be referred to.

SN74AS825ADWRE4 Features

Tape & Reel (TR) package
74AS series
24 pins
5V power supplies

SN74AS825ADWRE4 Applications

There are a lot of Texas Instruments SN74AS825ADWRE4 Flip Flops applications.

• Storage registers
• Single Up Count-Control Line
• QML qualified product
• Registers
• Digital electronics systems
• Load Control
• Test & Measurement
• Computers
• Guaranteed simultaneous switching noise level
• Matched Rise and Fall