Shipping overseas is convenient due to the electrical component's packing in 8-LSSOP, 8-MSOP (0.110, 2.80mm Width). To ensure high reliability, a new packaging method Tape & Reel (TR) is used. A switch device like this is mounted in Surface Mount. 2:1 is the ratio of multiplexer to demultiplexer circuits. Operating temperature extended to -40°C~85°C TA. Total terminations are 8. This electronic part offers high-quality output due to its 2 channels. With a 1.1V voltage supply, the electrical component should be turned on and run. Electronic part bodies are injected with 8 pins. A SPDT switching circuit is used to build these analog multiplexers. It consists of 1 circuits. Try searching for the analog switch ic with 74AUC2G53 if you are looking for variants. This digital multiplexer has 15Ohm internal resistance. The datasheets for the 8 pins explain the functions. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 2.7V should not normally be supplied to the switches. Analog switch ics with Single supply type are cost-effective. A low voltage of 800mV should be applied to the electronic component. The switch device would be able to operate with 10μA current. A voltage of 0.8V~2.7V is required for this switch device, which drains from a single voltage source. If you put voltage higher than 10μA on the digital multiplexer, damage may occur. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. There are 2 inputs to be operated. It is possible to transfer data over a 500MHz-bandwidth.