SN74HC374NSR Overview

The item is packaged in 20-SOIC (0.209, 5.30mm Width)cases. You can find it in the Cut Tape (CT)package. Currently, the output is configured to use Tri-State, Non-Inverted. This trigger uses the value Positive Edge. Surface Mountis positioned in the way of this electronic part. The supply voltage is set to 2V~6V. A temperature of -40°C~85°C TAis used in the operation. This D latch has the type D-Type. The 74HCseries comprises this type of FPGA. Its output frequency should not exceed 70MHz Hz. In total, there are 1 elements. 20terminations have occurred. The 74HC374family includes it. Power is provided by a 5V supply. A JK flip flop with a 3pFfarad input capacitance is used here. This D flip flop belongs to the family of HC/UH. It is mounted by the way of Surface Mount. This board has 20 pins. This device has Positive Edgeas its clock edge trigger type. This part is included in FF/Latches. The design is based on 8bits. As soon as 6Vis reached, Vsup reaches its maximum value. For normal operation, the supply voltage (Vsup) should be above 2V. Using 8 circuits, it is highly flexible. Considering the reliability of this T flip flop, it is well suited for TR. The power supply is 2/6V. A total of 2ports are embedded in the D flip flop. If high efficiency is desired, the supply voltage should be kept at 5V. With an output current of 7.8mA, it is possible to design the device in any way you want. The number of input lines is 3. There is 8μA quiescent current consumption by it.

SN74HC374NSR Features

Cut Tape (CT) package
74HC series
20 pins
8 Bits
2/6V power supplies

SN74HC374NSR Applications

There are a lot of Texas Instruments SN74HC374NSR Flip Flops applications.

• Computing
• 2 – Bit synchronous counter
• Synchronous counter
• Asynchronous counter
• Automotive
• Functionally equivalent to the MC10/100EL29
• Single Up Count-Control Line
• Patented noise
• Guaranteed simultaneous switching noise level
• Individual Asynchronous Resets