SN74HC4066PWRG4 Overview

This electronic part is conveniently packaged in 14-TSSOP (0.173, 4.40mm Width), making it easy to ship abroad. High reliability is ensured by the advanced packaging method Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operation at a temperature around -40°C~85°C TA. In total, 14 terminations have occurred. Due to its 4 channels, the electrical component produces high-quality output. Turning on and running the electrical part should be easy with a 4.5V voltage supply. It is part of the design of the 14 series that this electronic component is included. A SPST - NO switching circuit is used for these analog switches. Try searching with 74HC4066 to find analog multiplexer variants. A 30Ohm internal resistance characterizes this multiplexer. Please refer to the datasheets for 14 pins functions. The analog multiplexer shown here is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 6V to the switch device in normal circumstances. The analog switch ic is of the Single supply type and is cost-effective. It is recommended that the electrical component receives a voltage of 2V. An operating current of 2μA would be sufficient for this switch device. This analog switch requires a voltage of 2V~6V to drain from a single voltage supply. It may damage the digital multiplexer if the voltage is higher than 2μA. In this switch multiplexer, there are SEPARATE OUTPUT outputs available. The data can be transferred over a wide range of bandwidths, called 30MHz bandwidths.

SN74HC4066PWRG4 Features

4 Channels
Switch Circuit: SPST - NO
2μA Supply Current
Bandwidth: 30MHz

SN74HC4066PWRG4 Applications

There are a lot of Texas Instruments SN74HC4066PWRG4 Analog Switches & Multiplexers ICs applications.

• Avionics and Military Systems
• Medical systems
• Microprocessor Controlled Analog Systems
• FTTH
• Remote wireless modules
• PBXs
• Access Concentrators
• Sample hold systems
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• ATM