SN74HCT273DWRE4 Overview
The package is in the form of SOIC. As part of the package Tape & Reel (TR), it is embedded. 20terminations have occurred. It is powered by a voltage of 5V . A device of this type belongs to the family of HCT. It is mounted in the way of Surface Mount. There are 20pins on it. The clock edge trigger type for this device is Positive Edge. The RS flip flops belongs to FF/Latch base part number. An electronic part with 8bits has been designed. In order to achieve its superior flexibility, 8 circuits are used. A reliable performance of this D flip flop makes it well suited for use in TAPE AND REEL. A power supply of 5Vis required to operate it. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. There are no output lines on the JK flip flop. 3input lines are available for you to choose from. A high level output current of -4mAis set. In the low level output current setting, the current is set to 4mA. Ideally, the operating temperature should be below 85°C. If the operating temperature is higher than -40°C, the system should operate properly. In order for it to operate, a supply voltage of 4.5Vis required. A maximum voltage of 5.5V can be provided by it. This frequency can be achieved at 37MHz. There is a logic IC D FLIP-FLOP used in the D flip flop. It has 1 functions. 20pins are available on this JK flip flop.
SN74HCT273DWRE4 Features
Tape & Reel (TR) package
20 pins
8 Bits
5V power supplies
1 Functions
20 pin count
SN74HCT273DWRE4 Applications
There are a lot of Texas Instruments
SN74HCT273DWRE4 Flip Flops applications.
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
