SN74HCT374DBR Overview

The flip flop is packaged in 20-SSOP (0.209, 5.30mm Width). There is an embedded version in the package Cut Tape (CT). As configured, the output uses Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. A temperature of -40°C~85°C TAis used in the operation. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 74HCTseries FPGA. You should not exceed 40MHzin the output frequency of the device. In total, it contains 1 elements. As a result, it consumes 8μA quiescent current. A total of 20terminations have been recorded. The 74HCT374 family contains it. An input voltage of 5Vpowers the D latch. JK flip flop input capacitance is 3pF farads. In terms of electronic devices, this device belongs to the HCTfamily of devices. It is mounted by the way of Surface Mount. The 20pins are designed into the board. This device has Positive Edgeas its clock edge trigger type. The part is included in FF/Latches. An electronic part with 8bits has been designed. Despite its superior flexibility, it relies on 8 circuits to achieve it. This D flip flop is well suited for TR based on its reliable performance. The D latch runs on a voltage of 5V volts. The flip flop has 2embedded ports. For high efficiency, the supply voltage should be set to 5V. As of now, there are 3input lines.

SN74HCT374DBR Features

Cut Tape (CT) package
74HCT series
20 pins
8 Bits
5V power supplies

SN74HCT374DBR Applications

There are a lot of Texas Instruments SN74HCT374DBR Flip Flops applications.

• QML qualified product
• High Performance Logic for test systems
• Count Modes
• Dynamic threshold performance
• EMI reduction circuitry
• Shift registers
• Modulo – n – counter
• ATE
• ESD protection
• Cold spare funcion