SN74LS173ADRE4 Overview
16-SOIC (0.154, 3.90mm Width)is the way it is packaged. Package Tape & Reel (TR)embeds it. T flip flop uses Tri-State, Non-Invertedas the output. It is configured with the trigger Positive Edge. Surface Mountmounts this electrical part. The supply voltage is set to 4.75V~5.25V. It is operating at 0°C~70°C TA. It belongs to the type D-Typeof flip flops. FPGAs belonging to the 74LSseries contain this type of chip. You should not exceed 50MHzin its output frequency. In total, it contains 1 elements. There have been 16 terminations. This D latch belongs to the family of 74LS173. A voltage of 5V is used to power it. A device of this type belongs to the family of LS. It is mounted by the way of Surface Mount. The electronic flip flop is designed with pins 16. The clock edge trigger type for this device is Positive Edge. The part is included in FF/Latches. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TAPE AND REEL. The D latch runs on a voltage of 5V volts. This T flip flop features a maximum design flexibility due to its output current of 24mA. This input has 2lines. Additionally, you may refer to the D latch's additional WITH HOLD MODE; WITH DUAL OUTPUT ENABLE; DISABLE TIME CL = 5PF.
SN74LS173ADRE4 Features
Tape & Reel (TR) package
74LS series
16 pins
5V power supplies
SN74LS173ADRE4 Applications
There are a lot of Texas Instruments SN74LS173ADRE4 Flip Flops applications.
- ESD protection
- Convert a momentary switch to a toggle switch
- Control circuits
- Common Clocks
- Guaranteed simultaneous switching noise level
- Frequency Divider circuits
- ESD performance
- Modulo – n – counter
- Single Down Count-Control Line
- Circuit Design
