SN74LS173ADRG4 Overview
As a result, it is packaged as 16-SOIC (0.154, 3.90mm Width). As part of the package Tape & Reel (TR), it is embedded. In the configuration, Tri-State, Non-Invertedis used as the output. This trigger uses the value Positive Edge. It is mounted in the way of Surface Mount. A voltage of 4.75V~5.25Vis required for its operation. Temperature is set to 0°C~70°C TA. This electronic flip flop is of type D-Type. The 74LSseries comprises this type of FPGA. It should not exceed 50MHzin terms of its output frequency. A total of 1elements are present in it. There is 24mA quiescent consumption. There have been 16 terminations. The 74LS173 family contains it. Power is supplied from a voltage of 5V volts. In terms of electronic devices, this device belongs to the LSfamily of devices. Surface Mount mounts this electronic component. As you can see from the design, it has pins with 16. A Positive Edgeclock edge trigger is used in this device. This RS flip flops is a part number FF/Latches. An electronic part with 4bits has been designed. As soon as Vsup reaches 5.25V, the maximum supply voltage is reached. Due to its reliability, this T flip flop is well suited for TAPE AND REEL. An electrical current of 5V volts is applied to it. This T flip flop features a maximum design flexibility due to its output current of 24mA. There are 4 output lines on it. Additionally, you may refer to the additional WITH HOLD MODE; WITH DUAL OUTPUT ENABLE; DISABLE TIME CL = 5PF of the electronic flip flop.
SN74LS173ADRG4 Features
Tape & Reel (TR) package
74LS series
16 pins
4 Bits
5V power supplies
SN74LS173ADRG4 Applications
There are a lot of Texas Instruments SN74LS173ADRG4 Flip Flops applications.
- Power down protection
- Pattern generators
- Count Modes
- Guaranteed simultaneous switching noise level
- Latch
- Single Up Count-Control Line
- CMOS Process
- Computers
- Shift Registers
- Safety Clamp
