SN74LS174N Overview

16-DIP (0.300, 7.62mm)is the packaging method. You can find it in the Tubepackage. As configured, the output uses Non-Inverted. This trigger is configured to use Positive Edge. Through Holemounts this electrical part. A 4.75V~5.25Vsupply voltage is required for it to operate. A temperature of 0°C~70°C TAis used in the operation. D-Typeis the type of this D latch. The FPGA belongs to the 74LS series. Its output frequency should not exceed 40MHz. The list contains 1 elements. It consumes 26mA of quiescent current without being affected by external factors. There have been 16 terminations. JK flip flop belongs to 74LS174 family. The power source is powered by 5V. A device of this type belongs to the family of LS. The electronic part is mounted in the way of Through Hole. This board is designed with 16pins on it. This device has the clock edge trigger type of Positive Edge. The RS flip flops belongs to FF/Latches base part number. To achieve this superior flexibility, 7 circuits are used. The D latch runs on a voltage of 5V volts. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. As a result of its output current of 8mA, it is very flexible in terms of design. The number of input lines is 2. It is of 4 channels.

SN74LS174N Features

Tube package
74LS series
16 pins
5V power supplies

SN74LS174N Applications

There are a lot of Texas Instruments SN74LS174N Flip Flops applications.

• Common Clocks
• Computing
• Balanced Propagation Delays
• Bus hold
• Divide a clock signal by 2 or 4
• Single Down Count-Control Line
• Shift registers
• Buffer registers
• Test & Measurement
• Modulo – n – counter