SN74LS374DBR Overview

As a result, it is packaged as 20-SSOP (0.209, 5.30mm Width). As part of the package Tape & Reel (TR), it is embedded. T flip flop uses Tri-State, Non-Invertedas its output configuration. Positive Edgeis the trigger it is configured with. Surface Mountis positioned in the way of this electronic part. A voltage of 4.75V~5.25Vis required for its operation. It is operating at 0°C~70°C TA. It belongs to the type D-Typeof flip flops. It is a type of FPGA belonging to the 74LS series. In order for it to function properly, its output frequency should not exceed 50MHz. D latch consists of 1 elements. As a result, it consumes 40mA quiescent current and is not affected by external forces. There have been 20 terminations. This D latch belongs to the family of 74LS374. A voltage of 5V provides power to the D latch. It is a member of the LSfamily of D flip flop. A part of the electronic system is mounted in the way of Surface Mount. This board has 20 pins. This device's clock edge trigger type is Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. An electronic part designed with 8bits is used in this application. The superior flexibility of this product is achieved by using 8 circuits. Due to its reliability, this T flip flop is well suited for TR. The system runs on a power supply of 5V watts. The flip flop contains 2ports. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. This T flip flop features a maximum design flexibility due to its output current of 24mA. It has 3lines.

SN74LS374DBR Features

Tape & Reel (TR) package
74LS series
20 pins
8 Bits
5V power supplies

SN74LS374DBR Applications

There are a lot of Texas Instruments SN74LS374DBR Flip Flops applications.

• ESCC
• Buffered Clock
• Digital electronics systems
• Memory
• ATE
• Count Modes
• Single Down Count-Control Line
• Buffer registers
• Bounce elimination switch
• Test & Measurement