SN74LV174ADRE4 Overview
The flip flop is packaged in SOIC. Package Tape & Reel (TR)embeds it. Currently, there are 16 terminations. The D flip flop is powered by a voltage of 2.5V . Devices in the LV/LV-A/LVX/Hfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 16pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. An electronic part designed with 6bits is used in this application. Its superior flexibility is attributed to its use of 7 circuits. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. It runs on 3.3Vvolts of power. It has 1 output lines to operate. As of now, there are 2input lines. -12mA is set as the high level output current. In the low level output current setting, 12mAis used. It is recommended that the operating temperature be below 85°C. Ideally, the operating temperature should be higher than -40°C. A minimum supply voltage of 2V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 5.5V. It is possible to achieve 180MHz frequencies. It uses a logic IC with a D FLIP-FLOP value. A total of 1 functions are available on the T flip flop. There are 16 pins on the D latch. This flip flop features a maximum design flexibility due to its output current of 12mA.
SN74LV174ADRE4 Features
Tape & Reel (TR) package
16 pins
6 Bits
3.3V power supplies
1 Functions
16 pin count
SN74LV174ADRE4 Applications
There are a lot of Texas Instruments
SN74LV174ADRE4 Flip Flops applications.
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
