SN74LV374ANSRE4 Overview
In the form of SOP, it has been packaged. There is an embedded version in the package Tape and Reel. The number of terminations is 20. An input voltage of 2.5Vpowers the D latch. In this case, the D flip flop belongs to the LV/LV-A/LVX/Hfamily. There is an electronic component mounted in the way of Surface Mount. 20pins are included in its design. This device's clock edge trigger type is Positive Edge. It is designed with a number of bits of 8. Using 8 circuits, it is highly flexible. In order for the device to operate, it requires 3.3V power supplies. The flip flop has 2embedded ports. The JK flip flop is with 1 output lines to operate. The number of input lines is 2. In this case, the high level output current is set to -16mA. 16mAis set as the low level output current. There should be a temperature below 125°Cduring operation. In order for the system to operate properly, the temperature should be higher than -40°C. The RS flip flop is designed to operate with a minimal supply voltage of 2VV. There is a maximum voltage support of 5.5V. A frequency of 170MHzcan be achieved. BUS DRIVERis the logic IC it uses. There are 1 functions available on this T flip flop. A total of 20 pins are present on this device. Its output current of 16mA allows for maximum design flexibility.
SN74LV374ANSRE4 Features
Tape and Reel package
20 pins
8 Bits
3.3V power supplies
1 Functions
20 pin count
SN74LV374ANSRE4 Applications
There are a lot of Texas Instruments
SN74LV374ANSRE4 Flip Flops applications.
- Counters
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
