This electronic part is conveniently packaged in 16-DIP (0.300, 7.62mm), making it easy to ship abroad. To ensure high reliability, a new packaging method Tube is used. This analog switch is mounted in Through Hole. The ratio between the number of multiplexer and demultiplexer circuits is 4:1. Extended operating temperature around -40°C~85°C TA. The total number of terminations is 16. A high-quality output is provided by the electrical component's 2 channels. If the voltage supply is 2.5V volts, the electrical component should be turned on and run. An electrical component like this is included in the 16 series. Based on SP4T switching circuits, these analog multiplexers work. A 2 circuit is present in this switch device. Search with 74LV4052 if you are looking for analog multiplexer variants. It has an internal resistance of 100Ohm. Datasheets for 16 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Users shouldn't supply more than 5.5V voltage to the switch device. Analogue multiplexer with a Single supply type that is cost-effective. The lowest voltage the electronic part should receive is 2V. This multiplexer would work with 20μA current. A voltage of 2V~5.5V is required for this switch device, which drains from a single voltage source. A DIFFERENTIAL MULTIPLEXER analog IC is integrated into the board. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. A 8 input needs to be operated. 50MHz bandwidths enable data to be transferred. It can conduct 4-bit signals.