Packed in 16-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have a ratio of 4:1. The operating temperature is extended to around -40°C~85°C TA. In total, there are 16 terminations. A high-quality output is provided by the electrical component's 2 channels. An 2.5V voltage supply should allow the electrical part to be turned on and run. This electronic part can be found in the 16 series. Circuits based on SP4T switching are used to construct these analog switch ics. It consists of 2 circuits. Try searching for the analog switch ic with 74LV4052 if you are looking for variants. There is 100Ohm internal resistance in this digital multiplexer. The datasheets for the 16 pins explain the functions. Theswitch device is a typical Multiplexer or Switches. Users shouldn't supply more than 5.5V voltage to the switch device. The digital multiplexer has a low cost Single supply. A low voltage of 2V should be applied to the electronic component. In order to operate this switch device, it would need a current of 20μA. This analogue multiplexer requires a voltage of 2V~5.5V when it drains from a single voltage supply. This product is integrated with an analog integrated circuit (IC) of type DIFFERENTIAL MULTIPLEXER. Operating the 8 inputs requires 8 inputs. 50MHz bandwidths enable data to be transferred. It has a Drain to Source resistance of 100Ohm ohms. It is capable of carrying out 4-bit operation.