SN74LVC2G53DCTRG4 Overview

The electronic part can be shipped overseas conveniently because it is packaged in 8-LSSOP, 8-MSOP (0.110, 2.80mm Width). The advanced packaging method Tape & Reel (TR) provides high reliability. Multiplexers like this are mounted in the Surface Mount position. 2:1 is the ratio between multiplexers and demultiplexers. Operating temperature around -40°C~85°C TA extended. In total, there are 8 terminations. A electrical component with 2 channels is capable of high-quality output. When the electronic component is given a voltage of 2.3V, it should be turned on and run. As part of the design of the 8 series, this electronic part has been incorporated into the system. Unlike digital switches, these are based on SPDT switching circuits. A total of 1 circuits make up this switch device. Try searching with 74LVC2G53 to find analog multiplexer variants. As far as internal resistance is concerned, it has 13Ohm. To find out what the functions of 8 pins are, please refer to their datasheets. In this analog multiplexer, the value is Multiplexers or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. Single supply type digital switch with a low cost. It is recommended that the electrical component receives a voltage of 1.65V. For this multiplexer to operate, 1μA current would be sufficient. A voltage of 1.65V~5.5V is required for this switch device, which drains from a single voltage source. It may damage the digital multiplexer if the voltage is higher than 1μA. A total of COMMON OUTPUT outputs are available on this analog switch ic. The electrical component supports 2 inputs. In 300MHz-bandwidths, data can be transferred.

SN74LVC2G53DCTRG4 Features

2 Channels
Switch Circuit: SPDT
1μA Supply Current
-3db Bandwidth: 300MHz
Bandwidth: 300MHz

SN74LVC2G53DCTRG4 Applications

There are a lot of Texas Instruments SN74LVC2G53DCTRG4 Analog Switches & Multiplexers ICs applications.

• ISDN NT1/TA
• High-Voltage
• Audio and video signal routing
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• Remote Powered Equipment
• Multi-Line E1 Interface Cards
• Cable Modem
• PBX interfaces
• Ultrasound
• Mechanical reed relay replacement