SN74LVC2G66YZAR Overview

Packed in 8-XFBGA, DSBGA, the electronic component is convenient for shipping overseas. A high level of reliability can be achieved through the use of an advanced packaging method Cut Tape (CT). Mounted in Surface Mount is this multiplexer. Multiplexers and demultiplexers have a ratio of 1:1. Around -40°C~85°C TA is the extended operating temperature. Total terminations are 8. This electronic part offers high-quality output due to its 2 channels. If the voltage supply is 2.3V volts, the electrical component should be turned on and run. As part of the design of the 8 series, this electronic part has been incorporated into the system. On the other hand, analog switches can be constructed using SPST - NO switching circuits. Try searching with 74LVC2G66 to find analog multiplexer variants. A 10Ohm internal resistance characterizes this multiplexer. Please refer to the datasheets for 8 pins functions. The analog multiplexer shown here is a typical Multiplexer or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. The digital multiplexer has a low cost Single supply. 1.65V is the lowest voltage the electrical component should receive. For this multiplexer to operate, 10μA current would be sufficient. A voltage of 1.65V~5.5V is required for this switch device, which drains from a single voltage source. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. This analog switch ic utilizes SEPARATE OUTPUT output.

SN74LVC2G66YZAR Features

2 Channels
Switch Circuit: SPST - NO
10μA Supply Current
-3db Bandwidth: 300MHz

SN74LVC2G66YZAR Applications

There are a lot of Texas Instruments SN74LVC2G66YZAR Analog Switches & Multiplexers ICs applications.

• Cellular phones
• Remote wireless modules
• Precision instrumentation
• Relay Replacement
• Public switching systems
• Medical systems
• Multiplexers
• Cable Modem
• Communication systems
• Remote Powered Equipment