TLC25L2CPWRG4 Overview
In the package, you will find a 8-TSSOP (0.173, 4.40mm Width)-case to contain the op amp ic. A General Purpose-type buffer amplifier is shown here. There is a Tape & Reel (TR) case that is delivered with the instrumentation amplifiers. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. Instrumentation amplifier is a part of Operational Amplifier. It has 8 pins that make up the linear amplifier. There is an input offset voltage of 1.1mV for this buffer op amp. Surface Mount is the recommended mounting type for this linear amplifier. Regarding the operating temperature of this device, instrumentation amplifier performs well at a temperature of 0°C~70°C . It is possible to operate this buffer amplifier from a supply current of 29μA . It is recommended to keep the voltage gain at 116.9dB at all times. The buffer amp consists of 2 circuits in total. TAPE AND REEL is adopted to pack the instrumentation amplifier. LinCMOS? corresponds to the op amp's series.
TLC25L2CPWRG4 Features
8 Pins
supply voltage of 5V
116.9dB voltage gain
TLC25L2CPWRG4 Applications
There are a lot of Texas Instruments TLC25L2CPWRG4 Instrumentational OP Amps applications.
- Commercial audio systems
- Test equipment
- Automotive sensors
- Weak signal detection
- Car stereo
- single/dual op amp sum and difference circuits
- Gaming industry
- Television
- High/low-pass filter circuit
- Logarithmic operation circuits
