TS5A2066DCURG4 Overview

The electronic part can be shipped overseas conveniently because it is packaged in 8-VFSOP (0.091, 2.30mm Width). Advanced packaging method Tape & Reel (TR) is used to provide high reliability. It is mounted in the position Surface Mount. 1:1 is the ratio between multiplexers and demultiplexers. Extended operating temperature around -40°C~85°C TA. In total, 8 terminations have occurred. Due to its 2 channels, the electrical component produces high-quality output. A 1.8V voltage supply should turn on and run the electronic component. The electrical component body receives 8 pins. A SPST - NO switching circuit is used to build these analog multiplexers. Look for analog switch ic variants by searching with TS5A2066. In this multiplexer, the internal resistance is 10Ohm. For details about the functions of 8 pins, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. Single supply type digital switch with a low cost. In order for the electronic part to function properly, the lowest voltage should be 1.65V. For this multiplexer to operate, 100nA current would be sufficient. Using a single voltage supply, this switch device consumes 1.65V~5.5V volts. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. The electrical component supports 2 inputs. In 300MHz-bandwidths, data can be transferred.

TS5A2066DCURG4 Features

2 Channels
Switch Circuit: SPST - NO
100nA Supply Current
Bandwidth: 300MHz

TS5A2066DCURG4 Applications

There are a lot of Texas Instruments TS5A2066DCURG4 Analog Switches & Multiplexers ICs applications.

• Video signal routing
• Isolation
• Modems
• High speed data transmission line cards
• USB 1.1 signal switching circuits
• Power routing
• High reliability control systems
• Switching Systems
• Communication systems
• Communications systems