Due to its 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) packaging, the electronic part is convenient for international shipping. High reliability is ensured by the advanced packaging method Tape & Reel (TR). In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have a ratio of 2:1. The operating temperature is extended to around -40°C~85°C TA. There are 10 terminations totally. The electronic part provides high-quality output because it has 2 channels. When a voltage supply of 1.8V is used, the electronic component should be turned on and run. The electrical component body receives 10 pins. The analog switch ics are built using SPDT switching circuits. Try searching with TS5A23159 if you're looking for variants. Analog switches have 1.1Ohm internal resistance. You can find the functions of the 10 pins in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. Single supply type digital switch with a low cost. It is recommended to use 1.65V as the lowest voltage for the electrical part. In order to operate this switch device, it would need a current of 10nA. Using a single voltage supply, this switch device consumes 1.65V~5.5V volts. Putting voltage greater than 50nA on the multiplexer may cause damage. A 100MHz-bandwidth can be used for data transfer. This electrical component also includes additional features such as VIDEO APPLICATION. It has a Drain to Source resistance of 900mOhm ohms. Multiplexer ics with 4 outputs are available.
TS5A23159DGSR Features
2 Channels Switch Circuit: SPDT 10nA Supply Current Bandwidth: 100MHz Additional Features: VIDEO APPLICATION Drain-to-Source resistance: 900mOhm
TS5A23159DGSR Applications
There are a lot of Texas Instruments TS5A23159DGSR Analog Switches & Multiplexers ICs applications.