Packed in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width), the electronic component is convenient for shipping overseas. This packaging method provides high reliability because it uses advanced packaging techniques. In Surface Mount, this analog switch is mounted. There is 2:1 ratio between the number of multiplexers and demultiplexers. Extended operating temperature around -40°C~85°C TA. Total terminations are 10. As a result of its 2 channels, this electronic component provides high-quality output. In the case of a voltage supply of 1.8V volts, the electrical part can be powered up and run. It is part of the design of the 10 series that this electronic component is included. SPDT switching circuits are used in these analog switch ics. Try searching for the analog switch ic with TS5A23160 if you are looking for variants. A 900mOhm internal resistance characterizes this multiplexer. Datasheets for 10 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. Digital switch that provides Single power at a cost-effective price. It is recommended that the electrical component receives a voltage of 1.65V. This digital switch can be operated with a current of 10nA. A voltage of 1.65V~5.5V is required for this switch device, which drains from a single voltage source. The switch multiplexer may be damaged if it is exposed to voltage greater than 500nA. 100MHz-bandwidths can be used to transfer data between multiplexers. The analog switch ics has 4 outputs.