Due to its 8-VFSOP (0.091, 2.30mm Width) packaging, the electronic part is convenient for international shipping. High reliability is ensured by the advanced packaging method Tape & Reel (TR). There is an analog multiplexer mounted in position Surface Mount. Multiplexers and demultiplexers have the same number of circuits 2:1. Extended operating temperature around -40°C~85°C TA. In total, there have been 8 terminations. A 1 channel electronic part produces high-quality output. When the electronic component is given a voltage of 1.8V, it should be turned on and run. 8 pins are injected to the electronic part body. Unlike digital switches, these are based on SPDT switching circuits. It consists of 1 circuits. Look for analog switch ic variants by searching with TS5A3153. An switch multiplexer with 900mOhm internal resistance has a value of 900mOhm. The datasheets for the 8 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. Analog switch ics with Single supply type are cost-effective. 1.65V is the lowest voltage that should be fed to the electronic electronic part. For this digital switch to work, 20nA current would suffice. This analog switch requires a voltage of 1.65V~5.5V to drain from a single voltage supply. When the digital multiplexer is charged above 100nA, damage can occur. This switch operates within the bandwidth of 100MHz. There is also 2-CHANNEL MUX/DEMUX to look out for in this electronic part.