Shipping overseas is convenient with the electronic component packed in 6-TSSOP, SC-88, SOT-363. High reliability is provided by advanced packaging method Tape & Reel (TR). It is mounted in the position Surface Mount. Multiplexer and demultiplexer circuits have a number 2:1. The operating temperature is extended to around -40°C~85°C TA. 6 terminations have been made so far. Due to its 1 channels, the electrical component produces high-quality output. Turning on and running the electrical part should be easy with a 1.8V voltage supply. A key feature of the 6 series is the inclusion of this electronic part as part of its design. A SPDT switching circuit is used to build these analog multiplexers. Try searching for the analog switch ic with TS5A3159 if you are looking for variants. There is 1.1Ohm internal resistance in this digital multiplexer. The functions of 6 pins can be found in the datasheets. This switch device is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 5.5V to the switch device in normal circumstances. Analog switch ics with Single supply type are cost-effective. There should be 1.65V voltage fed to the electrical part below 1.65V. The analogue multiplexer could operate on 100nA current. Using only a single voltage supply, this analog switch requires 1.65V~5.5V voltage. Putting voltage greater than 100nA on the multiplexer may cause damage. In order to operate the 1 inputs, there are several steps to follow. A 100MHz-bandwidth can be used for data transfer. This electronic component presents a Drain to Source resistance of 1.5Ohm. An output of 2 is provided by the digital multiplexer.