The electrical component comes in SC-74A, SOT-753 packaging, which makes it convenient to ship overseas. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. In Surface Mount, this analog switch is mounted. There is 1:1 ratio between the number of multiplexers and demultiplexers. Extended operating temperature around -40°C~85°C TA. There are 5 terminations totally. This electronic part offers high-quality output due to its 1 channels. With a 1.8V voltage supply, the electrical component should be turned on and run. As part of the design of the 5 series, this electronic part has been incorporated into the system. These analog multiplexers are built based on SPST - NC switching circuits. Try searching for the analog switch ic with TS5A3167 if you are looking for variants. Internally, this switch multiplexer has a resistance of 900mOhm. Datasheets for 5 pin functions are available upon request. There is a standard Multiplexer or Switches analogue multiplexer here. Multiplexers should not be powered above 5.5V in normal situations. Analogue multiplexer with a Single supply type that is cost-effective. A low voltage of 1.65V should be applied to the electronic component. An operating current of 10nA would be sufficient for this switch device. This analogue multiplexer requires a voltage of 1.65V~5.5V when it drains from a single voltage supply. If put voltage greater than 100nA on the device, damage may be caused to the analogue multiplexer. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. The electrical component supports 1 inputs. In 200MHz-bandwidths, data can be transferred.