TS5A3357DCUT Overview

Shipping overseas is convenient with the electronic component packed in 8-VFSOP (0.091, 2.30mm Width). High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 3:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 8. High-quality output is provided by the electronic component's 1 channels. If the voltage supply is 1.8V volts, the electrical component should be turned on and run. The electronic part body is injected with 8 pins. A SP3T switching circuit is used to build these analog multiplexers. Try searching with TS5A3357 if you're looking for variants. There is 15Ohm internal resistance in this digital multiplexer. For functions related to 8 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. Analogue multiplexers of the Single supply type that are cost-effective. 1.65V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 1μA current would be sufficient. This analog switch requires a voltage of 1.65V~5.5V to drain from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 1μA. It is possible to operate 1 inputs. A 334MHz-bandwidth can be used for data transfer. Drain to Source resistance is 5Ohm. The analogue multiplexer has 3 outputs.

TS5A3357DCUT Features

1 Channels
Switch Circuit: SP3T
1μA Supply Current
Bandwidth: 334MHz
Drain-to-Source resistance: 5Ohm

TS5A3357DCUT Applications

There are a lot of Texas Instruments
TS5A3357DCUT Analog Switches & Multiplexers ICs applications.

• Transmit
• Low-Voltage
• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems