Shipping overseas is convenient with the electronic component packed in 8-VFSOP (0.091, 2.30mm Width). To ensure high reliability, a new packaging method Tape & Reel (TR) is used. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a number of circuits 3:1. Operation at a temperature around -40°C~85°C TA. In total, there have been 8 terminations. This electronic part offers high-quality output due to its 1 channels. In the case of a voltage supply of 1.8V volts, the electrical part can be powered up and run. A total of 8 pins are injected into the body of the electronic part. A SP3T switching circuit is used to build these analog multiplexers. Look for analog switch ic variants by searching with TS5A3359. This digital multiplexer has 900mOhm internal resistance. Datasheets for 8 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. Analogue multiplexer with a Single supply type that is cost-effective. 1.65V is the lowest voltage the electrical component should receive. 16nA current would be enough for this multiplexer to operate. Using a single voltage supply, this switch device consumes 1.65V~5.5V volts. When the digital multiplexer is charged above 50nA, damage can occur. A 100MHz-bandwidth can be used for data transfer. A Drain to Source resistance of 900mOhm is shown for this electronic part. 3 outputs are included in the analogue multiplexer.