TS5A4596DBVR Overview

The electrical component comes in SC-74A, SOT-753 packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 5 terminations have occurred. A electrical component with 1 channels is capable of high-quality output. When the electronic component is given a voltage of 3V, it should be turned on and run. Into the electrical component body are injected 5 pins. On the other hand, analog switches can be constructed using SPST - NO switching circuits. Look for analog switch ic variants by searching with TS5A4596. A 8Ohm internal resistance characterizes this multiplexer. The datasheets for the 5 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. A analog switch ic that has a cost-effective Single supply type. It is recommended to use 2V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 10nA current. Analogue multiplexers require a 2V~5.5V voltage to drain from a single voltage supply. A voltage higher than 250nA may cause damage to the switch multiplexer. It is possible to use COMMON OUTPUT outputs on this digital multiplexer. It is possible to transfer data over a 450MHz-bandwidth.

TS5A4596DBVR Features

1 Channels
Switch Circuit: SPST - NO
10nA Supply Current
Bandwidth: 450MHz

TS5A4596DBVR Applications

There are a lot of Texas Instruments
TS5A4596DBVR Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)