Presented in SOT-23-6, this electrical component is convenient for overseas shipping. High reliability is ensured by the advanced packaging method Tape & Reel (TR). There is an analog multiplexer mounted in position Surface Mount. Multiplexers and demultiplexers have the same number of circuits 2:1. Around -40°C~85°C TA is the extended operating temperature. Total terminations are 6. High-quality output is provided by the electronic component's 1 channels. With a 1.8V voltage supply, the electrical component should be turned on and run. As part of the design of the 6 series, this electronic part has been incorporated into the system. Multiplexers built on a SPDT switching circuit are built. A total of 1 circuits make up this switch device. Look for analog switch ic variants by searching with TS5A63157. It has an internal resistance of 10Ohm. To find out what the functions of 6 pins are, please refer to their datasheets. Theswitch device is a typical Multiplexer or Switches. Users should never supply a voltage higher than 5.5V to a switch device. A cost-effective Single supply type analogue multiplexer. 1.65V should be the lowest voltage fed to the electronic component. For this digital switch to work, 10nA current would suffice. Using only a single voltage supply, this analog switch requires 1.65V~5.5V voltage. Putting voltage greater than 100nA on the multiplexer may cause damage. This analog switch ic utilizes SEPARATE OUTPUT output. Operating the 2 inputs requires 2 inputs. 370MHz-bandwidths can be used to transfer data between multiplexers.