UC3879NG4 Overview

In the PDIP package, the switching controller meets most application requirements. There is sufficient capacity to generate switching controller for outputs 4. It can switch at 300kHz. A SWITCHING CONTROLLER analog integrated circuit is connected to the switch converters. DUAL are the position of the terminal of the switching converters. Various 20 terminations. This dc dc converter ic uses a variety of control techniques, including PULSE WIDTH MODULATION. There is a DC switcher's nominal voltage of 12V. There are 20 pins on switching converter. Specifically, switching converter falls under the Switching Regulator or Controllers category. DC regulator outputs 5V voltage based on test statistics. Because of DC switcher's Through Hole, it is suitable for most prototype designs and applications. A frequency of 500kHz is set for the switching controller. Hence, ALSO HAS CONTROL MODE OF IPK, ALSO HAS CONTROL TECHNIQUE OF RESONANT is used to better suit the DC to DC voltage regulator's situation. You should keep dc regulator at 0°C degrees or higher. There should be 70°C temperature above 70°C degrees Celsius when dc regulator runs. 1 functions (s) are included in the switch converters. Designing voltage regulators switchings with 20 pins. Switching can take place at a maximum frequency of 300kHz. It is possible to set the input voltage as 12V for nominal working statuses. This is an ideal solution for switching controllers with 10mA inputs. During normaloperations, it outputs a value of 2.2V. Voltage rating is 20V.

UC3879NG4 Features

Switching Frequency: 300kHz
PULSE WIDTH MODULATION
Frequency: 500kHz
ALSO HAS CONTROL MODE OF IPK, ALSO HAS CONTROL TECHNIQUE OF RESONANT

UC3879NG4 Applications

There are a lot of Texas Instruments
UC3879NG4 DC to DC converter applications.

• Network technology
• Automation technology
• CMM
• Various precision measuring instruments
• Various precision measuring detectors
• Flaw detection equipment
• Balance equipment
• Industrial robots
• Industrial controllers
• Die casting equipment