DG2743DQ-T1-E3 Overview

Due to its 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) Exposed Pad packaging, the electronic part is convenient for international shipping. High reliability is ensured by the advanced packaging method Tape & Reel (TR). It is mounted in the position Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. Operation at a temperature around -40°C~85°C TA. In total, there are 8 terminations. As a result of its 1 channels, this electronic component provides high-quality output. An 1.8V voltage supply should allow the electrical part to be turned on and run. Electronic part bodies are injected with 8 pins. Based on SPST - NO/NC switching circuits, these analog multiplexers work. Use DG2743 to search for variants of the digital switches. A 8Ohm internal resistance characterizes this multiplexer. You can find the functions of the 8 pins in the datasheets. This switch device is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 3.6V volts for the multiplexer. A analog switch ic that has a cost-effective Single supply type. A low voltage of 1.5V should be applied to the electronic component. The analogue multiplexer could operate on 10nA current. The voltage required by this switch device is 1.5V~3.6V, draining from a single voltage supply. Put voltage above 1μA on the multiplexer to cause damage. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. A voltage of 3V can be used to operate the electronic component. Operating the 2 inputs requires 2 inputs. Additional features of the electronic component include: VIDEO APPLICATION. There is 800mOhm Drain to Source resistance on this electronic part.

DG2743DQ-T1-E3 Features

1 Channels
Switch Circuit: SPST - NO/NC
10nA Supply Current
Additional Features: VIDEO APPLICATION
Drain-to-Source resistance: 800mOhm

DG2743DQ-T1-E3 Applications

There are a lot of Vishay Siliconix DG2743DQ-T1-E3 Analog Switches & Multiplexers ICs applications.

• Precision instrumentation
• Medical systems
• Imaging
• T1/E1 Terminals
• Relay Replacement
• Microprocessor Controlled Analog Systems
• Battery Powered Systems
• SONET
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• Data switching