DG2753DN-T1-E4 Overview

Due to its 16-VFQFN Exposed Pad packaging, the electronic part is convenient for international shipping. High reliability is provided by advanced packaging method Tape & Reel (TR). Mounted in Surface Mount is this multiplexer. 2:1 is the number of circuits in the multiplexer and demultiplexer. Extended operating temperature around -40°C~85°C TA. Total terminations are 16. A 1 channel electronic part produces high-quality output. An 2.7V voltage supply should allow the electrical part to be turned on and run. This electrical component is included in the 16 series of products. The analog switch ics are built using SPDT switching circuits. There are 3 circuits in this multiplexer. Try searching for the analog switch ic with DG2753 if you are looking for variants. A 600mOhm internal resistance characterizes this multiplexer. Datasheets for 16 pin functions are available upon request. Multiplexer or Switches is a typical switch device. It is normally recommended that users do not supply the multiplexer with voltages higher than 4.3V. The digital multiplexer has a low cost Single supply. The lowest voltage fed to the electronic component should be 1.65V. This digital switch can be operated with a current of 1μA. The voltage required by this switch device is 1.65V~4.3V, draining from a single voltage supply. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer.

DG2753DN-T1-E4 Features

1 Channels
Switch Circuit: SPDT
1μA Supply Current

DG2753DN-T1-E4 Applications

There are a lot of Vishay Siliconix DG2753DN-T1-E4 Analog Switches & Multiplexers ICs applications.

• Switching Systems
• PBXs
• Automatic test equipment
• Intelligent PBX
• Channelized and Unchannelized DS3 applications
• Audio and video switching
• Cable PC
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Communication systems
• Remote wireless modules