This electronic part is conveniently packaged in 16-DIP (0.300, 7.62mm), making it easy to ship abroad. A high level of reliability can be achieved through the use of an advanced packaging method Tube. In Through Hole, you'll find this switch device. Multiplexers and demultiplexers have the same number of circuits 1:1. Operation at a temperature around -40°C~85°C TA. In total, there are 16 terminations. High-quality output is provided by the electronic component's 1 channels. If the voltage supply is 15V volts, the electrical component should be turned on and run. It is part of the design of the 16 series that this electronic component is included. A SPST - NO/NC switching circuit is used for these analog switches. A 2 circuit is present in this switch device. Try searching with DG403 if you're looking for variants. This digital multiplexer has 45Ohm internal resistance. Datasheets for functions of 16 pins are available. Multiplexer or Switches is a typical switch device. It is generally not recommended to supply a voltage higher than 30V to the switch device in normal circumstances. Analog switch ics with Dual, Single supply type are cost-effective. 10V is the lowest voltage that should be fed to the electronic electronic part. This digital switch can be operated with a current of 10nA. Put voltage above 1μA on the multiplexer to cause damage. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 20V. With dual power supplies, you should attach at least 4.5V. It can operate from 12V operating voltages. A Drain to Source resistance of 30Ohm is shown for this electronic part. The analog switch ics includes 4 outputs.