Shipping overseas is convenient with the electronic component packed in 16-SOIC (0.154, 3.90mm Width). High reliability is provided by advanced packaging method Tube. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 16. As a result of its 1 channels, this electronic component provides high-quality output. A 15V voltage supply should turn on and run the electronic component. It is part of the design of the 16 series that this electronic component is included. Unlike digital switches, these are based on SPST - NC switching circuits. Search with DG441 if you are looking for analog multiplexer variants. In this multiplexer, the internal resistance is 85Ohm. For functions related to 16 pins, please refer to the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 36V. A analog switch ic that has a cost-effective Dual, Single supply type. 13V is the lowest voltage the electrical component should receive. It would be sufficient to run this analogue multiplexer with 15μA current. The analogue multiplexer may be damaged if voltage is greater than 100μA. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 22V. If you are using a dual power supply, you should attach at least 7V. There are SEPARATE OUTPUT outputs on this analog switch ic. The 4 inputs need to be operated in order to work. There is 85Ohm Drain to Source resistance on this electronic part.