DG442BDY-T1 Overview

Due to its 16-SOIC (0.154, 3.90mm Width) packaging, the electronic part is convenient for international shipping. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). It is mounted in the position Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Extended operating temperature around -40°C~85°C TA. Totally, there are 16 terminations. As a result of its 1 channels, this electronic component provides high-quality output. Powered by a 15V voltage supply, the electrical part should be switched on and run. As part of its design, the 16 series is equipped with this electronic component. These analog multiplexers are built based on SPST - NO switching circuits. A total of 4 circuits make up this switch device. It has an internal resistance of 80Ohm. The functions of 16 pins can be found in the datasheets. Multiplexer or Switches is a typical switch device. normally, users should not supply switches with voltages higher than 25V. A cost-effective Dual, Single supply type analogue multiplexer. There should be 13V voltage fed to the electrical part below 13V. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. Despite this switch device's dual supply capability, its voltage should not exceed 22V. It is recommended that you attach at least 7V to your dual power supply. SEPARATE OUTPUT outputs are utilized by this digital multiplexer.

DG442BDY-T1 Features

1 Channels
Switch Circuit: SPST - NO

DG442BDY-T1 Applications

There are a lot of Vishay Siliconix DG442BDY-T1 Analog Switches & Multiplexers ICs applications.

• Relay replacements
• Cellular phones
• DSUs
• PCMCIA cards
• Sample hold systems
• Ultrasound
• RGB switches
• Wireless Local Loop
• Cable PC
• Isolation