DG442DJ-E3 Overview

Presented in 16-DIP (0.300, 7.62mm), this electrical component is convenient for overseas shipping. High reliability is achieved by using advanced packaging method Tube. Multiplexers like this are mounted in the Through Hole position. Multiplexers and demultiplexers have a ratio of 1:1. Operating temperature around -40°C~85°C TA extended. 16 terminations have been made so far. As a result of its 1 channels, this electronic component provides high-quality output. It is safe to turn on and run the electronic component with a 15V voltage supply. It is injected into the electrical part body with 16 pins. These analog multiplexers are built based on SPST - NO switching circuits. Try searching for the analog switch ic with DG442 if you are looking for variants. Internally, this switch multiplexer has a resistance of 85Ohm. Datasheets for 16 pin functions are available upon request. It is a typical Multiplexer or Switches analog multiplexer. normally, users should not supply switches with voltages higher than 36V. An effective Dual, Single supply digital multiplexer. The lowest voltage fed to the electronic component should be 13V. This multiplexer would work with 15μA current. If put voltage greater than 100μA on the device, damage may be caused to the analogue multiplexer. Despite this switch device's dual supply capability, its voltage should not exceed 22V. In the case of dual power supplies, you should connect at least 7V. There are SEPARATE OUTPUT outputs on this analog switch ic. There are 4 inputs to be operated. There is 85Ohm Drain to Source resistance on this electronic part.

DG442DJ-E3 Features

1 Channels
Switch Circuit: SPST - NO
15μA Supply Current
Drain-to-Source resistance: 85Ohm

DG442DJ-E3 Applications

There are a lot of Vishay Siliconix DG442DJ-E3 Analog Switches & Multiplexers ICs applications.

• DSLAMs
• T1/E1 Terminals
• DSUs
• Avionics test equipment
• Modems
• Data switching
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Optical Applications
• Audio signal routing
• Audio/video switches