Due to its 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) Exposed Pad packaging, the electronic part is convenient for international shipping. High reliability is achieved by using advanced packaging method Tape & Reel (TR). Mounted in Surface Mount is this multiplexer. Multiplexers and demultiplexers have the same number of circuits 1:1. Operation at a temperature around -40°C~85°C TA. A total of 8 terminations have been recorded. The electronic part delivers high-quality output through its 1 channels. Turning on and running the electrical part should be easy with a 3V voltage supply. Electronic part bodies are injected with 8 pins. SPST - NC switching circuits are used in these analog switch ics. DG9262 can be used to search for analog multiplexer variants. Internally, this switch multiplexer has a resistance of 60Ohm. You can find the functions of the 8 pins in the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 12V. Digital switch that provides Single power at a cost-effective price. In order for the electronic part to function properly, the lowest voltage should be 2.7V. The switch device would be able to operate with 1μA current. The voltage required by this switch device is 2.7V~12V, draining from a single voltage supply. It may damage the digital multiplexer if the voltage is higher than 1μA. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. Operating 2 inputs is required. Drain to Source resistance for this electronic component is 60Ohm.