ADG1219BRJZ-REEL7 Overview

The electronic part can be shipped overseas conveniently because it is packaged in SOT-23-8. High reliability is provided by advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. In the multiplexer and demultiplexer, 2:1 represents the number of circuits. Operating temperature around -40°C~125°C TA extended. There are 8 terminations totally. By its 1 channels, the electronic component provides high-quality output. Powered by a 15V voltage supply, the electrical part should be switched on and run. As part of the design of the 8 series, this electronic part has been incorporated into the system. SPDT switching circuits are used in these analog switch ics. Look for analog switch ic variants by searching with ADG1219. In this multiplexer, the internal resistance is 200Ohm. The datasheets for the 8 pins explain the functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 16.5V. Dual, Single supply type digital switch with a low cost. In order for the electronic part to function properly, the lowest voltage should be 5V. If you put voltage higher than 190μA on the digital multiplexer, damage may occur. If put voltage greater than 16.5V on the multiplexer, damage may be caused to the device. The voltage should be at least 5V if you are using dual power supplies. Operating voltages range from 12V. There are 1 inputs to be operated. The transfer of data can be performed over 520MHz bandwidths. The Drain to Source resistance of this electronic component is 200Ohm. The analog switch ics has 2 outputs.

ADG1219BRJZ-REEL7 Features

1 Channels
Switch Circuit: SPDT
Bandwidth: 520MHz
Drain-to-Source resistance: 200Ohm

ADG1219BRJZ-REEL7 Applications

There are a lot of Analog Devices Inc. ADG1219BRJZ-REEL7 Analog Switches & Multiplexers ICs applications.

• Avionics and Military Systems
• PDAs
• Precision instrumentation
• T1/E1 Terminals
• Industrial
• Battery Powered Systems
• PBX interfaces
• Modems
• Sample-and-hold systems
• New designs requiring multiplexer functions