As the electronic part is packed in 16-VQFN Exposed Pad, CSP, international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~125°C TA. Total terminations are 16. The electronic part provides high-quality output because it has 1 channels. Powered by a 5V voltage supply, the electrical part should be switched on and run. The electrical component body receives 16 pins. Circuits based on SPDT switching are used to construct these analog switch ics. Try searching with ADG1436 to find analog multiplexer variants. An switch multiplexer with 1.8Ohm internal resistance has a value of 1.8Ohm. Datasheets for 16 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 16.5V in normal situations. The analog switch ic is of the Dual, Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 5V. When the digital multiplexer is charged above 285μA, damage can occur. Despite this switch device's dual supply capability, its voltage should not exceed 16.5V. It is recommended that you attach at least 4.5V to your dual power supply. 12V operating voltages can be used with this electrical part. Operating the 2 inputs requires 2 inputs. There are 110MHz bandwidths for data transfer. It has a Drain to Source resistance of 1.8Ohm ohms. A analog switch ics with 4 outputs is included.